I am posting no start help right here on The Toolbox.
This is another excerpt from my No Start Diagnostic book, in response to
so many basic questions I receive on no start problems.
Many of these problems are due to basic things anyone can check.
This is from the part of the book dealing with a no start when there are no codes and the check engine light is not on.
This will be a two-part post, with part 2 coming next month.
Check back often for news and information.
No Start diagnostic: basic fuel system checks, part 1.
A diesel engine needs only three
things to start; air, fuel injected at the right time,
and compression. Compression
is partly a function of cranking speed, so batteries
or a starter that are too
weak to crank the engine fast enough will cause a no start.
The engine needs to
crank at a minimum of 130 rpm in order to start, so make sure it
does and use a
battery charger if needed.
The
most common causes of no start in the DT engine are low oil level,
an ICP
(injection control pressure) problem, and fuel issues. It is important to check
the
simplest, easiest things first. If no code or light is set a fuel problem
is often the cause.
It
is worthwhile to at least look at the air filter or preferably to shine a light
through it
to be sure it isn’t plugged. Also check the fuel filter, making sure
it is full of fuel.
An empty filter that makes a sucking noise when it is
loosened is a sure sign of a
restricted fuel line, filter, or tank pickup. If
in doubt, replace the filter.
If
a fuel delivery problem is suspected always check the pre-filter screen for
debris blockage. On pre-2004 engines it is a small bowl about the size of a
D-cell battery
behind the fuel filter. On EGR engines it is on the bottom of
the fuel filter canister.
Both bowls contain a cleanable screen and are sealed
by an O-ring.
Dual fuel tanks on 4300 trucks.
If
your 4000 series has dual fuel tanks, make sure there is fuel in the
passenger
side tank. The engine usually draws fuel from that tank, and an
electric fuel
pump transfers fuel from the driver side to
keep the same level in both.
If the
transfer pump fails the passenger tank can be sucked dry.
While
on the subject, smell the fuel and make sure someone didn’t fill the
tank with
gasoline. You would be amazed at the number of times professional mechanics
run
into this, and nobody ever knows who did it. Too much gasoline will cause
a no
start or at minimum rough running, low power, and amazing quantities
of foul-smelling
smoke.
Check back next month for part 2
No comments:
Post a Comment